{"product_id":"qbp595823","title":"Lopolight Tri-Color Anchor Light, 1NM, FB Base, 22m Cable, IP68","description":"\u003ch6\u003eOverview\u003c\/h6\u003e\u003cp\u003eThis Lopolight tri-color\/anchor navigation light with an FB (flat base) is a single masthead fixture that covers red and green sidelights (112.5° each), a 135° stern light, and a 360° white anchor light. It is rated for 1 NM visibility, runs on 10-32 VDC, and is sealed to IP68 for rain, spray, and washdowns.\u003c\/p\u003e\u003cp\u003eThis version is supplied with a 22 m cable for longer runs down a mast or radar pole. The housing is silver anodized aluminum with a PMMA lens and A4 stainless hardware, and the footprint is Ø92.5 mm. The standard tri-color\/anchor version is 68 mm tall; the Windex version is taller at 86 mm because of the illuminated Windex mount.\u003c\/p\u003e\u003ch6\u003eKey features\u003c\/h6\u003e\u003cul\u003e\n\u003cli\u003eCombined tri-color sectors and anchor light in one unit: red 112.5°, green 112.5°, white 135°, and white 360°\u003c\/li\u003e\n\u003cli\u003e1 NM visibility rating for boats listed under 12 m\u003c\/li\u003e\n\u003cli\u003e10-32 VDC input for 12 V and 24 V systems\u003c\/li\u003e\n\u003cli\u003eIP68 sealing for wet environments and regular deck washdowns\u003c\/li\u003e\n\u003cli\u003eFB (flat base) mounting with top-mount or underside-mount options to match access and rig layout\u003c\/li\u003e\n\u003cli\u003eSilver anodized aluminum (25 µ) housing, PMMA lens, and A4 stainless steel screws\u003c\/li\u003e\n\u003cli\u003eLow power draw at 2.6 W (150 mA at 12 VDC, 81 mA at 24 VDC)\u003c\/li\u003e\n\u003cli\u003eMinimum feed wire gauge: 0.5 mm2 (AWG22)\u003c\/li\u003e\n\u003cli\u003e22 m cable length for masthead installations where the switch panel is below\u003c\/li\u003e\n\u003c\/ul\u003e\u003ch6\u003eVariants\u003c\/h6\u003e\u003cp\u003eOffered with two function sets. Both share the same 1 NM optics, Ø92.5 mm footprint, IP68 sealing, and 10-32 VDC input.\u003c\/p\u003e\u003cp\u003eThe difference is the extra function at the top of the unit: anchor only, or anchor plus an illuminated Windex mount.\u003c\/p\u003e\u003cul\u003e\n\u003cli\u003e101-009-FB 22M: Additional functions - Anchor. This configuration gives you the tri-color sectors for sailing plus the 360° white anchor light in the same fixture.\u003c\/li\u003e\n\u003cli\u003e101-009W-FB 22M: Additional functions - Windex\/Anchor. Adds an illuminated Windex mount on top so a wind vane can be seen at night while keeping the tri-color and anchor functions in the same unit.\u003c\/li\u003e\n\u003c\/ul\u003e\u003ch6\u003eInstallation and setup\u003c\/h6\u003e\u003cp\u003eMount the unit level on a horizontal surface at the masthead, on a radar pole, or on a dedicated light platform where it has an unobstructed view. The FB base supports mounting from the top using three clearance holes, or from the underside using three M4 threaded holes, which helps when you cannot access the top once installed.\u003c\/p\u003e\u003cp\u003ePlan the cable route before fastening the light. Leave a service loop, support the cable so it cannot chafe inside the spar, and seal the penetration where it passes into the mast or deck to keep water out.\u003c\/p\u003e\u003ch6\u003eElectrical and system integration\u003c\/h6\u003e\u003cp\u003ePower is 10-32 VDC, so it fits typical 12 V and 24 V boats without a converter. Wire it to a navigation-light switch panel or controller that supports a combined tri-color and anchor light. On the Windex\/Anchor version, the Windex mount light is an additional function that is normally handled as its own circuit at the switch panel.\u003c\/p\u003e\u003ch6\u003eUse cases on board\u003c\/h6\u003e\u003cp\u003eGood match for coastal cruising and overnight passages on smaller sailboats where you want one fitting at the masthead and you want to keep electrical load modest. The Windex\/Anchor option is a practical add-on for boats that sail with a wind vane and want it readable from the cockpit after dark.\u003c\/p\u003e\u003ch6\u003eMaintenance and care\u003c\/h6\u003e\u003cp\u003eRinse the housing and lens with fresh water after salt exposure and avoid abrasive pads that can haze the PMMA lens. During rig checks, confirm the fasteners are snug and the cable is still properly supported where it enters the spar.\u003c\/p\u003e","brand":"Lopolight","offers":[{"title":"Anchor","offer_id":52371104563381,"sku":"QBP595823-V1","price":927.03,"currency_code":"USD","in_stock":false},{"title":"Windex\/Anchor","offer_id":52371104596149,"sku":"QBP595823-V2","price":927.03,"currency_code":"USD","in_stock":false}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0977\/8171\/1029\/files\/1319333_qbp595823.webp?v=1774059746","url":"https:\/\/www.qualityboatparts.com\/products\/qbp595823","provider":"Quality Boat Parts","version":"1.0","type":"link"}