{"product_id":"qbp141809","title":"Lumishore ECLIPSE SL100 LED Strip Light, 5m, Blue\/White, 12V, IP68","description":"\u003ch6\u003eOverview\u003c\/h6\u003e\u003cp\u003eThe Lumishore 010-04485-00 is a 5 m dual-color strip light that lets you switch between blue and white light (5000 K white).\u003c\/p\u003e\u003cp\u003eIt runs on 12V DC systems only (10 to 15V DC). The strip is IP68-rated, fully encapsulated and potted, and measures 10.8 mm wide by 4.0 mm thick, so it fits into tight reveals under gunwales, coamings, and cabinetry.\u003c\/p\u003e\u003cp\u003eFor circuit planning, allow up to 0.5 A per meter (6 W\/m). On the dual-color version, only one color channel should be powered at a time.\u003c\/p\u003e\u003ch6\u003eKey features\u003c\/h6\u003e\u003cul\u003e\n\u003cli\u003e5 m strip length\u003c\/li\u003e\n\u003cli\u003eSwitchable blue and white output, with white at 5000 K\u003c\/li\u003e\n\u003cli\u003e12V DC only supply range (10 to 15V DC)\u003c\/li\u003e\n\u003cli\u003eUp to 0.5 A per meter (6 W\/m) for load calculations\u003c\/li\u003e\n\u003cli\u003eIP68 ingress protection with fully encapsulated, potted construction\u003c\/li\u003e\n\u003cli\u003eLow-profile 10.8 mm x 4.0 mm cross section for narrow mounting spaces\u003c\/li\u003e\n\u003cli\u003eCut to length in 50 mm steps, then seal the cut end before installation\u003c\/li\u003e\n\u003cli\u003eSimple 2-wire installation with control via an on\/off\/on switch or an Eclipse Command Center\u003c\/li\u003e\n\u003c\/ul\u003e\u003ch6\u003eInstallation and setup\u003c\/h6\u003e\u003cp\u003eLay the strip out straight before mounting and avoid twisting or bending it in the horizontal axis. Keep the bend radius to at least 50 mm and bend only in the vertical axis. For runs over 1 m, it helps to have a second person hold and uncoil the reel so the strip does not kink while you place it.\u003c\/p\u003e\u003cp\u003eIf trimming to fit, cut only at the marked cut points, then seal the cut end and allow the sealant to cure fully before handling. When using the adhesive backing, clean the mounting surface thoroughly and press along the edges of the strip rather than over the LEDs.\u003c\/p\u003e\u003cp\u003eThis strip can be installed indoors or in wet areas, but it is not intended for locations where it will be permanently submerged.\u003c\/p\u003e\u003ch6\u003eElectrical and control notes\u003c\/h6\u003e\u003cp\u003eUse a properly fused 12V feed and keep supply voltage within 10 to 15V DC. With dual-color wiring, do not connect both the blue and white channels so they can be on at the same time.\u003c\/p\u003e\u003cp\u003eBasic switching supports on\/off control and color selection. When used with an Eclipse Command Center, the same strip can also be dimmed and managed in zones where that system is installed.\u003c\/p\u003e\u003ch6\u003eCompatibility and fit\u003c\/h6\u003e\u003cp\u003eThe 10.8 mm x 4.0 mm profile suits trim channels, toe-kicks, and other shallow recesses where you want light without a bulky housing. Plan your run around the full 5 m length and the 50 mm cut increments so your endpoints land cleanly at a cut point.\u003c\/p\u003e\u003ch6\u003eUse cases on board\u003c\/h6\u003e\u003cp\u003eBlue and white switching works well for cockpit and helm accent lighting, under-gunwale glow on fishing boats, and cabin courtesy lighting where you want a softer night option alongside neutral white. It is a good match for boats wired on 12V DC that need low-profile accent lighting in areas that see spray and routine washdowns.\u003c\/p\u003e\u003ch6\u003eMaintenance and care\u003c\/h6\u003e\u003cp\u003eRinse salt residue when practical and avoid harsh chemical cleaners on the strip or freshly sealed ends. If the strip has been cut and sealed, check the sealed end during routine inspections, especially in high-splash locations.\u003c\/p\u003e","brand":"Lumishore","offers":[{"title":"Default Title","offer_id":52256231293109,"sku":"QBP141809","price":180.05,"currency_code":"USD","in_stock":false}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0977\/8171\/1029\/files\/1284932_qbp141809.webp?v=1771286764","url":"https:\/\/www.qualityboatparts.com\/products\/qbp141809","provider":"Quality Boat Parts","version":"1.0","type":"link"}