{"product_id":"qbp126781","title":"Lumishore LUX 4 in LED Flood Light, CRGBW Color Change, 2700K-6500K Tunable White, White Finish, 10.5-31V DC, IP68, 1,050 Fixture Lumens, 70-90° Oval Beam","description":"\u003ch6\u003eOverview\u003c\/h6\u003e\u003cp\u003eThe Lumishore 010-04459-00 is a 4 inch above-water CRGBW LED flood light in a white finish that covers working white light and full color accent lighting from the same fixture.\u003c\/p\u003e\u003cp\u003eIt runs on 10.5 to 31 V DC for 12 V and 24 V boats, draws up to 1.7 A at 12 V (0.9 A at 24 V), and is rated at 1,050 fixture lumens in white with a 70 to 90 degree oval beam. The housing is IP68, with a powder-coated aluminium body, a frosted lens, and a single stainless steel fixing bracket.\u003c\/p\u003e\u003cp\u003eControl is handled through the LUX lighting system. The light connects to a LUX light control module using a simple three wire harness (power, ground, data), and color or dimming can be managed from an EOS-LUX command center or a customer supplied momentary switch.\u003c\/p\u003e\u003ch6\u003eKey features\u003c\/h6\u003e\u003cul\u003e\n\u003cli\u003eCRGBW output with tunable white from 2700K to 6500K plus full spectrum RGB color\u003c\/li\u003e\n\u003cli\u003e10.5 to 31 V DC input for 12 V and 24 V electrical systems\u003c\/li\u003e\n\u003cli\u003e1,050 fixture lumens (white) with a 70 to 90 degree oval beam\u003c\/li\u003e\n\u003cli\u003eIP68 ingress rating for exposed mounting locations above the waterline\u003c\/li\u003e\n\u003cli\u003ePowder-coated aluminium housing with frosted lens and stainless steel fixing bracket\u003c\/li\u003e\n\u003cli\u003e35 cm (13.8 in) light cable for a short, tidy run to the control module\u003c\/li\u003e\n\u003cli\u003eThree wire connection: red power, black ground, yellow data\u003c\/li\u003e\n\u003cli\u003eOne LUX light control module supports up to five flood lights, with larger systems expandable up to 16 lights\u003c\/li\u003e\n\u003cli\u003eReverse polarity protection and 3,000 V surge protection built into the electronics\u003c\/li\u003e\n\u003cli\u003e3 year warranty\u003c\/li\u003e\n\u003c\/ul\u003e\u003ch6\u003eInstallation and setup\u003c\/h6\u003e\u003cp\u003eMount the bracket on a flat, solid surface where the light can aim across the work area without being shaded by rails or antennas. The bracket uses a 6.5 mm hole sized for an M6 bolt, and the cable pass-through hole is 6 mm. Keep the cable fixed so it cannot twist at the entry.\u003c\/p\u003e\u003cp\u003eSeal the cable entry and use a cable gland when the wiring drops into a hardtop, coaming, or transom void. When fastening the light to the stainless bracket, place the nylon washers against the bracket and tighten to 5 Nm to avoid crushing the hardware.\u003c\/p\u003e\u003ch6\u003eElectrical and system integration\u003c\/h6\u003e\u003cp\u003eThis light is not a stand-alone lamp on a simple two wire switch. It must be connected to a LUX light control module, and each lighting circuit should be fused appropriately for the wiring used. Wiring should follow ABYC guidelines, and all grounds should return to a common ground point with the module.\u003c\/p\u003e\u003cp\u003eOn boats with multiple flood lights, keep the module count in mind: up to five lights can share one module, and larger installs can be split across modules up to a total of 16 lights. Bonding is not required for the fixture.\u003c\/p\u003e\u003ch6\u003eDimensions and mounting considerations\u003c\/h6\u003e\u003cp\u003eOverall size with the bracket is 10.6 x 4.5 x 5.8 cm (4.20 x 1.77 x 2.29 in), and the light weighs about 250 g (0.5 lb). The short 35 cm lead is meant to land close to the control module, so plan the module location early if you are wiring through an overhead, arch, or cockpit coaming.\u003c\/p\u003e\u003ch6\u003eUse on board\u003c\/h6\u003e\u003cp\u003eFor docking and deck work, tunable white lets you keep the tone warm around the cockpit or push it cooler when you want more contrast for cleanup. The RGB channels are useful for low glare ambience at anchor or for matching other LUX lighting zones without adding separate accent lights.\u003c\/p\u003e\u003cp\u003eThis is a good match for boats that already run the LUX lighting system and want a compact flood light for a hardtop, T-top, arch, or aft-facing mount above the waterline.\u003c\/p\u003e\u003ch6\u003eMaintenance and care\u003c\/h6\u003e\u003cp\u003eWash salt off with fresh water and clean the lens with soap and water using a soft cloth. Avoid chemical cleaners and do not power wash the fixture. Inspect the bracket hardware and cable entry as part of routine washdowns, especially on boats that see heavy spray.\u003c\/p\u003e","brand":"Lumishore","offers":[{"title":"Default Title","offer_id":52256229228725,"sku":"QBP126781","price":342.99,"currency_code":"USD","in_stock":false}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0977\/8171\/1029\/files\/1284907_qbp126781.jpg?v=1771286735","url":"https:\/\/www.qualityboatparts.com\/products\/qbp126781","provider":"Quality Boat Parts","version":"1.0","type":"link"}