{"product_id":"qbp097684","title":"JL Audio M6-770ETXv3 7.7in Enclosed Tower Marine Coaxial Speakers, 100W RMS, 4 Ohm, Pair, Gloss White Enclosure, Gloss White Classic Grille, Black Tweeter Mesh, Mounting Clamps Sold Separately","description":"\u003ch6\u003eOverview\u003c\/h6\u003e\u003cp\u003eThe JL Audio 010-03276-00 is a 7.7-inch enclosed tower coaxial speaker system sold as a pair for boats that need sound that carries in open air (model M6-770ETXv3-Gw-C-GwGw). Each speaker is a 4 ohm load with 100 W RMS continuous power handling, and it is typically paired with an amplifier in the 40 to 200 W per-channel range.\u003c\/p\u003e\u003cp\u003eThis configuration comes in a gloss white enclosure with a gloss white trim ring and gloss white classic grille, finished with black tweeter mesh. The enclosure measures 7.70 in (196 mm) in diameter and 12.62 in (321 mm) deep, with an overall height of 8.74 in (222 mm) when you account for the clamp receiver.\u003c\/p\u003e\u003ch6\u003eKey features\u003c\/h6\u003e\u003cul\u003e\n\u003cli\u003ePair of 7.7-inch enclosed coaxial tower speakers for mounting up high on a tower or other structure, with the option to surface mount when the hardware setup supports it\u003c\/li\u003e\n\u003cli\u003e4 ohm nominal impedance with 100 W RMS continuous power handling; recommended amplifier power is 40 to 200 W per channel\u003c\/li\u003e\n\u003cli\u003e45 Hz to 25 kHz frequency response with 91.0 dB efficiency (1 W at 1 m) for practical output in windy, open-water conditions\u003c\/li\u003e\n\u003cli\u003eFlying-lead speaker connections with 16 AWG wire, 10 ft per speaker, to make clean routing to an amp or distribution point easier\u003c\/li\u003e\n\u003cli\u003eEnclosed housing dimensions: 7.70 in diameter and 12.62 in depth; 8.74 in overall height including the clamp receiver\u003c\/li\u003e\n\u003cli\u003eMounting clamps are required and sold separately, so you can match the hardware to your tower tubing and mounting layout\u003c\/li\u003e\n\u003cli\u003eConstruction that exceeds international standards for salt fog and UV exposure for long-term use on open boats\u003c\/li\u003e\n\u003c\/ul\u003e\u003ch6\u003eCompatibility and fit\u003c\/h6\u003e\u003cp\u003eThis is an enclosed tower-style speaker system intended for installations where the speakers sit above head level, such as wake towers, hardtops, T-tops, radar arches, and other tubular structures. It also supports surface-mount style installs when the chosen hardware and mounting surface allow for a secure, vibration-resistant fit.\u003c\/p\u003e\u003cp\u003eBecause the mounting clamps are not included, fit is determined by the mounting fixtures you select. Confirm the tubing diameter and available clearance before ordering clamps, and check that the speaker body depth and rotation will not interfere with canvas, lights, antennas, or tower folds.\u003c\/p\u003e\u003ch6\u003eInstallation and setup\u003c\/h6\u003e\u003cp\u003ePlan your wire run from the tower to the amplifier before mounting. The speaker leads are 16 AWG and 10 ft long, which covers many tower-to-helm routes, but longer boats often benefit from junction points or extended runs using appropriately sized marine speaker cable.\u003c\/p\u003e\u003cp\u003eUse drip loops and protected routing where the wire passes through tubing or near sharp edges. Once installed, seal any penetrations and secure the cable so it cannot chafe under vibration or when the tower is folded.\u003c\/p\u003e\u003ch6\u003eElectrical and amplifier notes\u003c\/h6\u003e\u003cp\u003eThese speakers present a 4 ohm load, so verify your amplifier is stable at the wiring configuration you plan to use. If you are running multiple speakers per channel, map out the final impedance at the amp terminals before you commit to series or parallel wiring.\u003c\/p\u003e\u003cp\u003eThey are rated for 100 W RMS continuous handling per speaker, which helps when matching amplifier output and setting gain so the system plays cleanly without pushing the speakers into distortion.\u003c\/p\u003e\u003ch6\u003eUse cases on board\u003c\/h6\u003e\u003cp\u003eThis setup makes sense for wake and surf boats, center consoles with a hardtop or T-top, and pontoons with a tower where passengers and riders need music that stays present in wind and engine noise. It is also a good match for owners upgrading from small pod speakers who want a larger 7.7-inch format in an enclosed housing while keeping mounting flexible through clamp selection.\u003c\/p\u003e\u003ch6\u003eMaintenance and care\u003c\/h6\u003e\u003cp\u003eRinse with fresh water after saltwater runs and keep the grilles free of dried salt and sunscreen residue. If the boat is stored outdoors, a tower cover helps reduce long-term UV exposure on finished surfaces between trips.\u003c\/p\u003e","brand":"JL Audio","offers":[{"title":"Default Title","offer_id":52256223789237,"sku":"QBP097684","price":846.83,"currency_code":"USD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0977\/8171\/1029\/files\/1284791_qbp097684.jpg?v=1771286671","url":"https:\/\/www.qualityboatparts.com\/products\/qbp097684","provider":"Quality Boat Parts","version":"1.0","type":"link"}